Retirar un vinilo para vehículos de un vehículo puede ser difícil, especialmente si está envuelto alrededor de todos los bordes. Aquí tienes algunos consejos para lograr una retirada limpia y eficiente. Tomemos como ejemplo un cofre, ya que es una superficie de aplicación bastante grande y puede ser complicado retirar una pieza tan grande de vinilo para vehículos.
Divídelo en secciones
Si es difícil retirar un panel gigante, la forma más conveniente es dividirlo en secciones antes de retirarlo. Primero afila tu cuchilla y luego haz ligeros cortes sobre el vinilo para vehículos con la hoja afilada.
(Cortar directamente sobre la superficie siempre implica riesgos. Si necesitas más confianza, haz una prueba con un trozo de sobrante sobre una mesa de trabajo para encontrar la presión adecuada que debes aplicar con tu cuchilla.)
Corta alrededor del borde superior del cofre y haz varios cortes verticales en la superficie principal, como si estuvieras creando franjas. Solo toca el vinilo con la cuchilla y márcalo ligeramente.
No tienes que cortarlo por completo. Si el material no se rompe, puedes hacer otro corte más tarde. La clave en esta etapa es rayar el vinilo y ayudarte a encontrar el punto de inicio para despegarlo.
Retíralo
Puedes comenzar desde el borde cerca del parabrisas. Encuentra tu punto de inicio y retira un poco del vinilo en la parte superior. Luego tendrás acceso a las “franjas” en la superficie principal.
Al despegar el vinilo, hazlo rápidamente para garantizar una retirada limpia. Si encuentras una pieza grande que no está separada correctamente, haz otro corte en la dirección adecuada para dividirla primero en franjas.
Una vez que termines el cofre, retirar el vinilo de las demás secciones debería ser sencillo. Si tienes problemas con un área en particular, aplica calor al material e inténtalo de nuevo. El material debería retirarse sin problemas. Más información sobre vinilos para vehículos en teckwrap.com.
1 comentario
Why would you EVER consider cutting the vinyl directly on the hood in order to “section” it off into strips?! I don’t care how skilled at cutting someone is, it’s just a matter of time before problems arise…
To tackle a hood, I’d start at the back corners near the A-pillars and pull up the vinyl facing the windshield first (just past where it rounds the top edge). Then working along the fender facing sides towards the front of the hood and finish unwrapping the front edge before moving to the main area. Starting from any of the corners (I start from the front), use a little heat and begin making low (30-40 degree), quick “popping” short pulls away from the direction you’re removing (similar to removing a command strip but instead of slowly pulling low and back you want to make quick popping motions to “snap” up the vinyl to help avoid leaving excess adhesive on the surface). Continue working around the perimeter of the hood working towards the center or back of the hood until the removal is complete.