Cashmere Rose Color PPF (CPX313)

No, and the difference is the material. Vinyl is PVC and it is there to change the color. Color PPF is TPU, a thicker elastomer that absorbs impact and closes its own light scratches with heat. You are buying stone chip protection that happens to change the color, which is why it costs what it costs.

Depends on what you are protecting against. If you want a new color for the next few years and the car lives an ordinary life, a wrap does that at a fraction of the cost. If the car takes highway miles, gravel, track days or a hard commute, and you want the paint underneath untouched when it comes off, this is the film for that job.

Glossier than either, usually. TPU with a gloss top coat throws a wetter, deeper reflection than most factory paint, which is why a gloss color PPF car reads as freshly detailed permanently. If you wrap only part of the car, that difference is visible against the untreated panels.

Almost always marring in the top coat, not damage to the color. Park it in the sun or run warm water over it and most of it closes. Marks that survive that went deeper than the healing layer, and those need the panel replaced.

Less than a thin film would, but it is not a cover up. This film is thick, so shallow texture and light orange peel largely disappear under it. Dents, filler ridges and lifting clear coat still show, and gloss reflects them straight back at you.

Yes, and this is the difference nobody warns you about. On clear film an overlap disappears. On pigmented film every overlap is a double thickness of color, so it reads as a visible darker line from ten feet away. Plan the panel layout so seams fall in shadow lines and gaps, and expect fewer, larger pieces than a clear job.

Only if they have installed TPU before. Color PPF stretches further, grabs differently, needs slip solution and does not forgive the habits that work on vinyl. The most expensive mistakes on this film are made by good vinyl installers on their first PPF car. Ask for TPU work in their portfolio, not wrap work.

Never. A blade on paint is a scratch you have paid for twice, and knifeless tape leaves a line in a film this thick. Use plotted patterns and wrapped edges. If a panel has no pattern available, the piece gets cut off the car and tucked, not scored on it.

Only if the paint is fully cured and sound. Fresh paint outgasses for weeks and traps solvent under the film. Weak or previously repaired paint can lift on removal, and a film with this much adhesion and thickness is less forgiving about it than a wrap. Test an inconspicuous area first.

No to both. It bonds to paint, not to another film's top coat, and layering traps edges that lift. Strip what is on the car first.

Optional and worth it on gloss. A PPF safe coating cuts washing time, resists water spotting and keeps sap and droppings from keying in. Use a coating rated for PPF top coats. Aggressive paint coatings and any polishing compound will damage the healing layer, permanently.

Normally, with two buckets and pH neutral soap, and no machine polishing ever. Polishing removes the self healing top coat, and once that is gone nothing heals again. Dry with a blower or a plush towel, and keep pressure washers back from the wrapped edges.

Light marks, yes. Wash swirls, fingernail scratches at the door handle and fine marring close up with heat, from the sun on a warm day or from warm water. Anything that went through the top coat into the color layer does not come back.