How To Vinyl Wrap A Spoiler
Your spoiler takes the worst of the sun and road debris, and its curves, tight edges, and bolt holes make it the perfect practice piece for vinyl wrapping. This guide...
Installation Articles
How To Vinyl Wrap A Spoiler
-
Wrapping with pre-cut vinyl film | TeckWrap
Cutting material such as craft vinyl film is a must-have for personalizing your vehicle or branding for a business purpose. It is also a good choice when you feel like...
-
Car wrapping: Maintain heat gun in good shape | TeckWrap
Many car wrap installers might have experienced that scraps of the vinyl film end up getting to the tip of your heat gun. This is something you should deal with,...
-
Key fact about gloss car wrap | TeckWrap
A gloss car wrap is not that difficult to wrap with, and this is because of its easy-going properties. Here are some key facts about it. Let’s check out how...
-
Vinyl Cutting: What you should pay attention | TeckWrap
Cutting is an essential skill for every wrapper installing vinyl film. A clean cut can distinguish a perfect finish from other wrap jobs. Yet a bad cut can ruin your...
-
Car wrapping: Eliminating impression on roll | TeckWrap
Often, for a color-change or full print car wrap roll, there will be impressions like scratches or stripes on its surface, whether it is gloss or matte vinyl. This might...
-
Proper workflow: Wrapping Tesla hood with vinyl film | TeckWrap
The hood of Tesla is usually not complicated to wrap with vinyl film. With the right approach and workflow, it can become one easy-peasy. Here is how you can do...
-
Leave the antenna on for vinyl wrapping | TeckWrap
Sometimes, it makes the vinyl wrapping process much easier when removing all the hardware in a section. But sometimes it is not. For example, when wrapping a roof, it is...
-
Vinyl wrapping: Avoid adhesive dots | TeckWrap
When wrapping a hood or roof with vinyl wrap film, you will see peaks and curves on the section. They are generally not as hard to wrap as those deeply...
-
Avoid uneven heat: vinyl wrapping recessed area
When heating a vinyl film on recessed areas during wrapping, the uncertainty is that you might make part of it too hot and too cold on its other areas. And...
-
Vinyl cutting: Stretch with zero tension | TeckWrap
Usually, when you stretch a vinyl wrap film, there will be tension. And if you overstretch and cut it, a significant amount of wrinkles will occur when you apply heat...
-
Vinyl installing: Safe emblem removal｜TeckWrap
Removing emblems can essentially help with the vinyl film wrapping process, as you can do the job more smoothly with no hassle. But this job can be tricky sometimes, especially...
-
Fender wrapping: Leave the hardware｜TeckWrap
Is every hardware removal necessary for vinyl film wrapping? The answer might be no. If you are doing a color-change project with a white vehicle, would you consider removing all...
-
Vinyl wrapping roof with grooves｜TeckWrap
A roof is not a tiny section to wrap with vinyl wrap film, and it is challenging to make everything under control when wrapping it. Thus, sometimes you might accidentally damage...
