TeckWrap Digital Print Media

Film construction
Film type: polymeric PVC printing film with air-release channel adhesive
Film thickness: 70 ± 2 μm (PF52005 printing film)
Overlaminate thickness: 70 ± 2 μm (LF52005-HD gloss, LF52005M matte, LF52005SCM super matte)
Base film finish: white, semi-matte with a light ceramic sheen. Final finish is set by the overlaminate
Release liner: plastic release liner, silicone-coated on one side, air-release channels
Roll size, printing film: 1.52 m × 39 m (59.8" × 128 ft)
Roll size, overlaminate: 1.52 m × 40 m (59.8" × 131 ft)
Material: polymeric PVC with a stable white base for accurate color reproduction
Adhesive: pressure-sensitive adhesive, transparent, repositionable on placement, permanent after cure

Performance
Print compatibility: solvent, eco-solvent, UV and latex printing
Outdoor durability: 3 years, vertical exposure, printed and overlaminated
Service temperature: -40°C to 80°C
Conformability: smooth surfaces and moderate curves. Panel graphics, fleet livery and partial wraps
Dimensional stability: polymeric construction holds registration through print, lamination and contour cutting
Finish options: gloss, matte and super matte overlaminate

Warranty
Three-year outdoor durability rating on vertical surfaces for printed and overlaminated graphics, based on manufacturer exposure testing.
Warranty covers manufacturing defects in the unprinted film, including adhesive failure, delamination and coating defects, when the film is stored, printed, laminated and installed to specification.
Ink adhesion, color fastness and print longevity depend on the printer, ink set and profile used, and fall outside TeckWrap control.
Durability figures assume the graphic is overlaminated. Unlaminated prints carry no outdoor durability rating.

Application temperature: +17°C to +23°C
Storage: 2 years in original packaging, 15°C to 25°C, 50% relative humidity, rolls suspended or stored upright
Printing: solvent, eco-solvent, UV or latex
Outgassing: allow solvent and eco-solvent prints to outgas 24 to 48 hours before laminating
Lamination: cold roll laminator at even tension. Never laminate a print that has not fully outgassed
Cutting: allow 24 hours after lamination before contour cutting so the stack is dimensionally settled
Tools: felt-edged squeegee, heat gun or steam, sharp blade
Conformability: smooth and medium-curved surfaces
Post-heat: 90°C on all stretched and recessed areas after installation
Cure: 24 hours above 10°C, 48 hours at room temperature recommended
Overlap: 3 to 4 mm
Avoid overstretching. Stretched printed film distorts the image before the film itself fails
Substrate: apply to sound original OEM paint. Repainted or damaged panels are the responsibility of the installer
Professional installation recommended
Aftercare: pH-neutral cleaners only, pH 3 to 11. Avoid waxes, harsh solvents and petroleum distillates. Hand wash preferred, keep high-pressure spray away from edges and seams

All TeckWrap statements, technical information, and recommendations are based on tests believed to be reliable but do not constitute a guarantee or warranty. All products are sold with the understanding that the buyer has independently determined the suitability of products for their purpose.

TeckWrap products are warranted to be free of defects in material for the period of shelf life. In case of defects, TeckWrap will replace the product or compensate at its sole discretion. This is the exclusive obligation of TeckWrap Inc.

Warranty does not cover normal wear, transportation, labor, or consequential damages.

Screen images may vary, refer to physical color swatches. Use same production LOT for color consistency. Scratches during application or daily use are not covered.