Common Causes of Vinyl Adhesion Failure
Avoid Car Wrap Lifting & Peeling – Get a Flawless Finish Every TimeDIY vinyl wrapping can be challenging, and adhesion failure is one of the most common issues. From poor...
How to install vinyl wrap
Common Causes of Vinyl Adhesion Failure
-
Flat and smooth vinyl: No more adhesive line｜TeckWrap
When wrapping with vinyl film, if there is an adhesive line, it can always ruin a finish. But sometimes, even though the surface is thoroughly clean and you handle the...
-
Clean and wrap right away? Not suitable for all vinyl films｜TeckWrap
It is easy to think that you are ready to install the vinyl film immediately as long as the surface is thoroughly cleaned and prepped. For gloss car wrap, this...
-
Hot or cold? Make vinyl wrapping under control｜TeckWrap
Climate matters a lot for the durability of vinyl film, as it can affect the life span of a car wrap. In the same way, the temperature in a wrapping...
-
Hood wrapping with vinyl: Which direction?｜TeckWrap
Today, many of the most popular types of vinyl wrap are directional films, including gloss and matte metallic, satin, and carbon fiber wraps. When wrapping with this kind of material,...
-
General tips for roof wrapping｜TeckWrap
Wrapping a roof with vinyl wrap film can be easy or sometimes challenging, depending on whether you have the right approach and pay attention to some small things. Here are...
-
Vinyl craft: General tips for cutting｜TeckWrap
For vinyl installation, cutting is a must-learn technique. It is also a skillful job and can determine whether you can achieve a perfect paint-like finish, which is the ultimate goal...
-
Vinyl stretching: Do it cold｜TeckWrap
Most vinyl wrap films in the market today have memory effect. At some point, a wrapper aims to eliminate the material’s memory to achieve a perfect finish. But sometimes, you...
-
Wrapping: Level up your vinyl squeegeeing skill｜TeckWrap
As an essential skill for vinyl film wrapping, squeegeeing matters a lot when installing a material. Doing it wrong might damage the film and lead to failure. Here are some...
-
Vinyl wrapping: what you shouldn’t neglect during the process｜TeckWrap
Installing vinyl wrap film is never only about wrapping. Many other things involved during the process are as important as the installation itself because the key to a perfect finish...
-
Vinyl wrapping: bumper with extended area at the bottom｜TeckWrap
Some bumpers have an attached extended area at the bottom, making the wrapping process a little bit complicated. It is ok to wrap the whole area in one piece for...
-
Wrapping sided hood in one piece｜TeckWrap
Usually, a hood is a straightaway piece of cover secured at the front of a vehicle. But some are sided with a one-centimeter-wide area underneath on the left and right....
-
Wrapping rear bumper with extended bottom area｜TeckWrap
Rear bumpers are usually not the most challenging part to wrap with vinyl film. But for some of those with an attachment at the bottom, which creates a recessed corner,...
-
Save vinyl and increase efficiency during pre-production｜TeckWrap
As more and more advanced technologies are applied to the vinyl film industry, the cost of a wrap has been relatively increased. And you certainly want to save as much...
